Synchronize audio data with timestamps by squeezing/stretching it and/or dropping samples/adding silence when needed.

This filter is not built by default, please use aresample to do squeezing/stretching.

It accepts the following parameters:

compensate

Enable stretching/squeezing the data to make it match the timestamps. Disabled by default. When disabled, time gaps are covered with silence.

min_delta

The minimum difference between timestamps and audio data (in seconds) to trigger adding/dropping samples. The default value is 0.1. If you get an imperfect sync with this filter, try setting this parameter to 0.

max_comp

The maximum compensation in samples per second. Only relevant with compensate=1. The default value is 500.

first_pts

Assume that the first PTS should be this value. The time base is 1 / sample rate. This allows for padding/trimming at the start of the stream. By default, no assumption is made about the first frame’s expected PTS, so no padding or trimming is done. For example, this could be set to 0 to pad the beginning with silence if an audio stream starts after the video stream or to trim any samples with a negative PTS due to encoder delay.