Video waveform monitor.

The waveform monitor plots color component intensity. By default luminance only. Each column of the waveform corresponds to a column of pixels in the source video.

It accepts the following options:

mode, m

Can be either row, or column. Default is column. In row mode, the graph on the left side represents color component value 0 and the right side represents value = 255. In column mode, the top side represents color component value = 0 and bottom side represents value = 255.

intensity, i

Set intensity. Smaller values are useful to find out how many values of the same luminance are distributed across input rows/columns. Default value is 0.04. Allowed range is [0, 1].

mirror, r

Set mirroring mode. 0 means unmirrored, 1 means mirrored. In mirrored mode, higher values will be represented on the left side for row mode and at the top for column mode. Default is 1 (mirrored).

display, d

Set display mode. It accepts the following values:

overlay

Presents information identical to that in the parade, except that the graphs representing color components are superimposed directly over one another.

This display mode makes it easier to spot relative differences or similarities in overlapping areas of the color components that are supposed to be identical, such as neutral whites, grays, or blacks.

stack

Display separate graph for the color components side by side in row mode or one below the other in column mode.

parade

Display separate graph for the color components side by side in column mode or one below the other in row mode.

Using this display mode makes it easy to spot color casts in the highlights and shadows of an image, by comparing the contours of the top and the bottom graphs of each waveform. Since whites, grays, and blacks are characterized by exactly equal amounts of red, green, and blue, neutral areas of the picture should display three waveforms of roughly equal width/height. If not, the correction is easy to perform by making level adjustments the three waveforms.

Default is stack.

components, c

Set which color components to display. Default is 1, which means only luminance or red color component if input is in RGB colorspace. If is set for example to 7 it will display all 3 (if) available color components.

envelope, e

none

No envelope, this is default.

instant

Instant envelope, minimum and maximum values presented in graph will be easily visible even with small step value.

peak

Hold minimum and maximum values presented in graph across time. This way you can still spot out of range values without constantly looking at waveforms.

peak+instant

Peak and instant envelope combined together.

filter, f

lowpass

No filtering, this is default.

flat

Luma and chroma combined together.

aflat

Similar as above, but shows difference between blue and red chroma.

xflat

Similar as above, but use different colors.

yflat

Similar as above, but again with different colors.

chroma

Displays only chroma.

color

Displays actual color value on waveform.

acolor

Similar as above, but with luma showing frequency of chroma values.

graticule, g

Set which graticule to display.

none

Do not display graticule.

green

Display green graticule showing legal broadcast ranges.

orange

Display orange graticule showing legal broadcast ranges.

invert

Display invert graticule showing legal broadcast ranges.

opacity, o

Set graticule opacity.

flags, fl

Set graticule flags.

numbers

Draw numbers above lines. By default enabled.

dots

Draw dots instead of lines.

scale, s

Set scale used for displaying graticule.

• digital
• millivolts
• ire

Default is digital.

bgopacity, b

Set background opacity.

tint0, t0, tint1, t1

Set tint for output. Only used with lowpass filter and when display is not overlay and input pixel formats are not RGB.