FFmpeg 2.4.14
Since* 2.0
#

Video stabilization/deshaking: pass 2 of 2, see vidstabdetect for pass 1.

Read a file with transform information for each frame and apply/compensate them. Together with the vidstabdetect filter this can be used to deshake videos. See also http://public.hronopik.de/vid.stab. It is important to also use the unsharp filter, see below.

To enable compilation of this filter you need to configure FFmpeg with --enable-libvidstab.

#

Options

input

Set path to the file used to read the transforms. Default value is transforms.trf).

smoothing

Set the number of frames (value*2 + 1) used for lowpass filtering the camera movements. Default value is 10.

For example a number of 10 means that 21 frames are used (10 in the past and 10 in the future) to smoothen the motion in the video. A larger values leads to a smoother video, but limits the acceleration of the camera (pan/tilt movements). 0 is a special case where a static camera is simulated.

optalgo

Set the camera path optimization algorithm.

Accepted values are:

gauss

gaussian kernel low-pass filter on camera motion (default)

avg

averaging on transformations

maxshift

Set maximal number of pixels to translate frames. Default value is -1, meaning no limit.

maxangle

Set maximal angle in radians (degree*PI/180) to rotate frames. Default value is -1, meaning no limit.

crop

Specify how to deal with borders that may be visible due to movement compensation.

Available values are:

keep

keep image information from previous frame (default)

black

fill the border black

invert

Invert transforms if set to 1. Default value is 0.

relative

Consider transforms as relative to previsou frame if set to 1, absolute if set to 0. Default value is 0.

zoom

Set percentage to zoom. A positive value will result in a zoom-in effect, a negative value in a zoom-out effect. Default value is 0 (no zoom).

optzoom

Set optimal zooming to avoid borders.

Accepted values are:

0

disabled

1

optimal static zoom value is determined (only very strong movements will lead to visible borders) (default)

2

optimal adaptive zoom value is determined (no borders will be visible), see zoomspeed

Note that the value given at zoom is added to the one calculated here.

zoomspeed

Set percent to zoom maximally each frame (enabled when optzoom is set to 2). Range is from 0 to 5, default value is 0.25.

interpol

Specify type of interpolation.

Available values are:

no

no interpolation

linear

linear only horizontal

bilinear

linear in both directions (default)

bicubic

cubic in both directions (slow)

tripod

Enable virtual tripod mode if set to 1, which is equivalent to relative=0:smoothing=0. Default value is 0.

Use also tripod option of vidstabdetect.

debug

Increase log verbosity if set to 1. Also the detected global motions are written to the temporary file global_motions.trf. Default value is 0.

#

Examples

  • Use ffmpeg for a typical stabilization with default values:

    ffmpeg -i inp.mpeg -vf vidstabtransform,unsharp=5:5:0.8:3:3:0.4 inp_stabilized.mpeg

    Note the use of the unsharp filter which is always recommended.

  • Zoom in a bit more and load transform data from a given file:

    vidstabtransform=zoom=5:input="mytransforms.trf"
  • Smoothen the video even more:

    vidstabtransform=smoothing=30