Trim the input so that the output contains one continuous subpart of the input.

It accepts the following parameters:

start

Specify the time of the start of the kept section, i.e. the frame with the timestamp start will be the first frame in the output.

end

Specify the time of the first frame that will be dropped, i.e. the frame immediately preceding the one with the timestamp end will be the last frame in the output.

start_pts

This is the same as start, except this option sets the start timestamp in timebase units instead of seconds.

end_pts

This is the same as end, except this option sets the end timestamp in timebase units instead of seconds.

duration

The maximum duration of the output in seconds.

start_frame

The number of the first frame that should be passed to the output.

end_frame

The number of the first frame that should be dropped.

start, end, and duration are expressed as time duration specifications; see the Time duration section in the ffmpeg-utils(1) manual for the accepted syntax.

Note that the first two sets of the start/end options and the duration option look at the frame timestamp, while the _frame variants simply count the frames that pass through the filter. Also note that this filter does not modify the timestamps. If you wish for the output timestamps to start at zero, insert a setpts filter after the trim filter.

If multiple start or end options are set, this filter tries to be greedy and keep all the frames that match at least one of the specified constraints. To keep only the part that matches all the constraints at once, chain multiple trim filters.

The defaults are such that all the input is kept. So it is possible to set e.g. just the end values to keep everything before the specified time.

Examples:

• Drop everything except the second minute of input:

  ffmpeg -i INPUT -vf trim=60:120

• Keep only the first second:

  ffmpeg -i INPUT -vf trim=duration=1